6g Weld Test -2" Schedule 80 6010 root 7018 cap UA-8

6g Weld Test -2" Schedule 80 6010 root 7018 cap UA-8

see the full article here http://goo.gl/CjfowJ and visit my store here http://weldmongerstore.com/ My good friend Andrew Cardin and I were making a 3g and 4g dual shield flux core video, and finished early so we also filmed this video on welding a 6g weld test with 3/32" 6010 root pass and 7018 cover pass. Its a common test...and it was the very first real welding test that I took....and failed. A big thanks to Andrew Cardin, Lincoln Electric, and Triangle Engineering (trieng.com) for help in making this video.

6g Pipe Welding Test 6010 Root Pass

6g Pipe Welding Test 6010 Root Pass

http://weldmongerstore.com/ http://www.weldingtipsandtricks.com/pipe-welding-6010.html a few tips for welding a root pass in a 6 inch 6g pipe with 6010 electrode. Fitup is as important as any welding technique so pay attention to getting as good a fit as possible. 75-100 amps is the range listed by the uc-28 spec sheet I read. I found that about 80 amps worked ok provided I used a 3/32" gap and heavy 3/32" land.

United Airlines Flight Experience: UA895 Hong Kong to Singapore

United Airlines Flight Experience: UA895 Hong Kong to Singapore

United Airlines Boeing 777-222/ER flight experience, onboard the 2nd leg of UA895, from Chicago to Singapore, via Hong Kong. The sector from Hong Kong to Singapore is a night departure, with a scheduled flight time of 3 hours and 55 minutes. The cabin crew offered newspapers during boarding. Dinner service commenced with the main course options of stir-fried noodles with dimsum or beef stew with potatoes. Drinks are served prior to landing. Thank you for watching this United Airlines flight experience on FlightTravels. Remember to subscribe! FlightTravels Travel Blog: http://www.flighttravels.net/ FlightTravels Facebook: https://www.facebook.com/FlightTravels/

6011 Stick Welding Quicky Fab

6011 Stick Welding Quicky Fab

See a more detailed article on welding with 6011 rods here http://www.weldingtipsandtricks.com/6011.html visit the new weldmonger store here http://weldmongerstore.com/ Stick welding with 6011 rod to make a temporary dolly for a cold saw. 6011 is a good rod for quick fab jobs because its an all position rod that also welds downhill and that works good on outside corner joints

6g Pipe Welding Test - Tips for Root Pass

6g Pipe Welding Test - Tips for Root Pass

http://welding-tv.com/the-store/ Tips that might just help you pass a 6g pipe welding test. this video is about the root pass and tips for using the "lay wire" technique. there are definitely other ways that work but this is one technique that has worked for me.

Top Videos -  loading... Change country
Load 5 more videos
 
 
Sorry, You can't play this video
00:00/00:00
  •  
  •  
  •  
  •  
  •  
  •  
  •  
CLOSE
CLOSE
CLOSE